Hi, some questions from a newbie if anyone can help:
1. Are Pahi's basically built using ply exopy fillet construction over moulds.
2. How are Tiki's built by comparison.
3. Is there a view as to which is the stronger more durable method.
4. how many sheets of ply would a Pahi 31 consume and what thickness would these be.
5. Is sheathing of the entire hull recommended even when BS 1088 ply is used throughout.
6. How many degrees would one expect a properly setup P31 to tack through in in moderate waves F4, with how much leeway.
7. Wharram designs were recently critised by another well known cat designer on another forum as having too many embellishments, do the raised ends of the Pahi hulls have a demonstrable function.
That is a lot to swallow in one go I know, but only the tip of the iceberg I am afraid. Any comments gratefully received.
These forums are now closed
The forums are closed to new contributions. For informational purposes, all posts will remain available to read here.
Quelqu'un aurait-il Supprimé les puits de dérives sur Pahi 31? N'utilisant pas mes dérives en navigation, j'aimerais Supprimer les puits de dérives. Y aurait-il un Problème Structurel?
What information is available to aid in construction without a roof (barn) for a Pahi 31?
Time perhaps for wharram desines to look at plans in aluminum aluminum has become very easey for the home builder more durable less maintenance so much faster to build with most wooden boats here are seen in museums